
Raven X 1x/EV-DO
21 20070914
Using Direct Commands to the Internal
Hardware
UseonlyiftheALEOSmethodisunsuccessful.
Activating the Modem
1. Settelnettimeoutinto20minutes.
AT*TELNETTIMEOUT=20
2. Savethetelnetsetting.
AT&W
3. VerifyALEOShasestablishedcommunicationtothe
internalhardware.
ATI3
4. Entertheusernameofyouraccount(NAI).Theuser
nameisusuallyexpressedasanemailaddresswithphone
numberoftheaccount(example,1234567@carrier.com).
Thisinformationshouldbeprovidedbyyourcarrier.You
maynotneedthisstep.
AT*NETUID=[NAI]
5. Enterthepasswordofyouraccount.Thisinformation
shouldbeprovidedbyyourcarrier.Youmaynotneedthis
step.
AT*NETPW=[password]
6. Putmodemintopassthrumodetoby‐passALEOS.This
willallowdirectcommunicationwiththewirelessmodule
forprogramming.Enteringpassthruwilltake10‐15
secondsandwillreturnan‘OK’whenitiscomplete.
AT\APASSTHRU
7. VerifyyouareinPassthrumode.
AT!STATUS
8. Unlockthemodule.
AT~NAMLCK=MSL
9. SettheMDNandMSID.
AT~NAMVAL=0,MDN,MSID,0,65535
10. Verifythesettingsarewhatyouintendedtoenter.
AT~NAMVAL?0
Note: If your carrier supports IOTA, start the IOTA session. Not all
carriers support IOTA. Please check with your carrier before you use
this command.
11. StarttheIOTAsession.
AT!IOTASTART
StatuswillbeoutputuntilIOTAcompleteswith‘IOTA
Successful’or‘1012ERROR’.
Comentarios a estos manuales