Sierra S5020 Información técnica descargar pdf (Pagina 29)

Arm/ Bypass

Arming With Not-Ready Zones

The zones in your system are not always ready to arm. For ex-

ample, a zone would not be ready to arm if one of its sensors has

been vandalized, needs service, or detects a potential alarm condi-

tion. Zones which are not ready to arm are referred to as not-ready

zones.

Your system has been programmed to automatically handle not-ready

zones in one of three ways described below. Refer to Section 8 to

see how your system was programmed.

Force Arming. With Force Arming, the system arms, even if

some not-ready zones exist. All not-ready zones are ignored

(bypassed) and therefore, not protected. Exception: Any faulted

Day Buzzer or Day Bell zones must be manually bypassed be-

fore arming can occur. These are zones that cause a buzzer or

bell to sound if they are faulted while the system is disarmed.

Chirp-Alert Arming. With Chirp-Alert Arming, your system does

not arm if a not-ready zone exists. At the end of the exit delay,

your system's sounders chirp. You must re-enter the building

and enter a user code, or an alarm sounds. Then, you must

either correct or manually bypass these zones before the sys-

tem can be armed.

Goof-Proof Arming. With Goof-Proof Arming, the system does

not arm if there are any not-ready exit zones (doors). Instead,

an alarm sounds at the end of the exit delay. You must re-enter

the building and correct the not-ready zones before arming can

occur.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 67 68

Sin comentarios

Sierra S5020 Información técnica Pagina 29